Gamlen M series – Manufacturing system
Custom small-batch tablet manufacturing
with portable benchtop flexibility for your laboratory
or manufacturing facility

Create, test and manufacture from your laboratory benchtop


✓ Plug in and go
✓ Works straight out of the box
✓ No training required
✓ Push-button control panel
✓ Tablet quality controlled on each tablet by
control of compaction force and tablet weight
✓ Manufacturing losses minimal (<1%)
✓ Suitable for use in a protected and controlled
GMP environment (eg isolator)
✓ Output 100-180 tablets per hour
✓ Compression mix dispensed using GamPette
(included with machine)

Two speed options: 1 mm/s and 4 mm/s


Download brochure


Your quick route to manufacturing small batches of tablets under tightly controlled conditions

 

Unique benefits include:

Quick and easy to use with tiny amounts of material
Improves tablet manufacturing process
Very low wastage rates, normally less than 1%
Being able to check product quality prior to putting batches onto production presses
Cheaper than compaction force simulator
Can be used in controlled humidity environment
Saves time, money and materials


Using the Gamlen M series you’ll be able to:

 

Quickly compare formulations
Test small quantities of material down to 10 mg
Manufacture preclinical and phase 1 product
Ideal for investigating tableting problems


Applications

 

Manufacture of test product batches
Formulation comparisons
Excipient compatibility samples
Manufacture of phase one clinical trials material


Quick and easy to operate

 

The Gamlen M series offers a quick route to the manufacture of small batches of tablets under tightly controlled conditions.

Sample powders (we recommend using the GamPette – accuracy ±2% or better for most materials).


Performance

 

  1. Manufacturing rate approximately 100-180 tablets per hour.
  2. The product can be manufactured under completely controlled compaction conditions including compaction rate and compaction force (all tablets) and temperature and humidity (when used with glove box).
  3. Doses as low as 10 mg, lower in some cases.
  4. Product yield essentially 100% – NO LOSS of valuable or scarce products.
  5. Fracture measurement- the press can change mode to hardness tester to measure tablet tensile strength.

M series specification

 

Tablet punch size 2-15 mm diameter
Material capacity of the die 2-400 mg
Tablets/min 3
Maximum load 500 kg
Load cell travel 30 mm
Test height Depends on pillar extension length.
Maximum extension of 300 mm
Load selection User selected on instrument panel
Operating speed 240 mm/min
Calibration Dead weights in kg or proving ring
Power requirements 110/120 VAC 3.15 A or 220/240 VAC 1.6 A (External selection via fuse holder)
Machine dimensions 310 w x 270 d x 375 h
Machine weight
(without accessories)
16 kg
Shipping size 390 x 350 x 390 or 460 x 430 x 480
Shipping weight approx 20 kg


GamPette-cutout-yellow-powderThe GamPette

 

We recommend using the GamPette to dispense accurate quantities (better than 2%) of powder into the die reproducibly.

The GamPette is a hand held powder pipette that accurately dispenses solids, comprising a dispensing handle and a controller unit. Tip sizes are available to accommodate a wide range of powder volumes. Powder is drawn into the pipette tip in the handle under vacuum and then expelled under light positive pressure.

Learn more about the GamPette

Contact us now if you have a question or would like a quotation

Comments are closed